SpiroCombi HC100F
Description
SpiroCombi HC-100-F Combined Air & Dirt Separator
Hi-Flow unit
• DN 100mm
• Flanged PN16
• Max operating pressure 10bar at 110°C
• Steel Construction
• Separation element constructed from Spirally Wound Copper tube
• Max flow rate 26 l/sec
• Max velocity 3 mtr sec
Benefits:
• Fast and efficient removal of air from system.
• Fastest possible commissioning of circuits – Repeatable gauge readings, no chasing of air around the system.
• Permanent air free system (including dissolved oxygen).
• No cavitation of circulating pumps.
• No more bleeding of radiators or other circuits.
• Silent operation of system, no cascading of air at system high points
• Very small particles, from 5 µm (=0.005mm) and up are separated and removed from the circulating water.
• Dirt can be drained form the unit whilst the system remains in operation
• No shut-off valves or bypass required
• Constant low pressure drop irrespective of how much dirt is in the unit
• Maintenance only takes a few seconds and is a simple clean task to undertake when compared to a standard “Y” type strainer or inline magnetic unit.
• No unnecessary shutdown of plant
Product Range Information
Spirotech HC Range of Combined Air & Dirt Separators, Hi Flow units up to 3 mtrs/sec velocity
All Air & Dirt Separators must create the correct environment to be able to work efficiently. The Spirotech brand uses a separation element constructed of spirally wound copper wire around a central copper core. This arrangement creates an area of laminar flow (static water) at the top and base of the unit enabling even the smallest of microbubbles and dirt particle to overcome the mass flow of the circulating fluid and then simply collect at the top (Air) or base (dirt) of the unit. It is the only point on the system where laminar flow exists when in normal operation.
However, if the flow rates are excessive the whole of the separator may become turbulent hence no laminar flow may exist, therefore it is necessary to provide some “guidance” as to the maximum flow for each size of unit. The chart below provides the required information to assist with product selection at a velocity of 3 mtr/sec.
DN L/sec Mtr3/hr Product
50mm 7 25 HC-050-F
65mm 11 40 HC-065-F
80mm 15 54 HC-080-F
100mm 25 94 HC-100-F
125mm 40 144 HC-125-F
150mm 60 216 HC-150-F
200mm 100 360 HC-200-F
250mm 160 576 HC-250-F
300mm 225 810 HC-300-F